Automotive Parts Links

REMANUFACTURING

Before remanufacturing, all a/c compressor cores are disassembled into components and sub components. The Components then go through an extensive cleaning process. After cleaning, all parts go through a visual inspection. The Components will then go through our remanufacturing process.


1. Body: Resurfaced and checked for OEM specs.
2. Pistons: Visual inspection and replaced if necessary.
3. Valve Plates: Resurfaced to OEM specs.
4. Valve Reeds: New or Resurfaced to OEM specs.
5. Bearings: Tested and replaced as needed.
6. All seals and gaskets are replaced and are R12 / R134-A Compatible.
7. Clutches are remanufactured as necessary.
8. During assembly units go through a quality control check at key points.
9. Compressors may be filled with Premium Polyol Ester Oil which is R12 / R134-A compatible. After assembly the compressors go through the toughest testing in the aftermarket.
10. Valve Plates are tested for proper discharge & suction pressure.
11. Compressor is put on a on car simulation to test for noise and proper operation.
12. Unit is then leak checked at high pressure using nitrogen. Nitrogen is lighter than air or freon.
13. Coils are checked electronically to make sure they meet OEM specs.
14. Clutches are then tested for proper operation using a on car simulation test

Nitrogen testing is used on all units for leaks because it is lighter than freon or air. On-car simulation tests are done as well for the best finished product. There are four total tests performed on each unit before it passes our quality control inspection. AIRCOPARTS.COM follows all recommended procedures and OEM spec's.

 

Google

 

About Us | Site Map | Privacy Policy | Contact Us | ©2005 Airco Auto Air